Wen 70711 10 inch Sliding Compound Miter Saw trouble s Manual de usuario descargar pdf

Compound Miter Saw 10 inch Sliding - 70711

Saw does not cut all the way through.

If the saw is not cutting all the way through, you can adjust the default depth by turning a

set screw located on the left side of the motor housing. The set screw is held tight by a

small nut. Loosen the nut and insert an Allen wrench in the top of the set screw. Turn

the set screw 1 turn counter-clockwise. Make a test cut to see if the depth is correct.

Repeat as needed. Do NOT over-adjust this set screw or it will allow the blade to cut into

base of the saw. Be sure the blue thumb screw next to it is adjusted to the desired depth

as well.

<<<<<<<<<<<<<<Depth Adjustment Set Screw

1 2 3

Indice de contenidos

Pagina 1

Compound Miter Saw 10 inch Sliding - 70711 Saw does not cut all the way through. If the saw is not cutting all the way through, you can adjust the de

Pagina 2

Saw does not cut straight We recommend that you check all adjustments with an accurate carpenter’s square: ADJUSTING THE FENCE 1. To adjust the F

Pagina 3

ADJUSTING THE BEVEL ANGLE 1. For making accurate cuts, the Saw Blade must be adjusted to be exactly vertical to the Table. 2. To check the angle, have

Comentarios a estos manuales

Sin comentarios

Wen 70711 10 inch Sliding Compound Miter Saw trouble s Manual de usuario

Busca en linea o descarga Manual de usuario para Herramientas Eléctricas Wen 70711 10 inch Sliding Compound Miter Saw trouble s. WEN 70711 10 inch Sliding Compound Miter Saw trouble shooting User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Wen 70711 10 inch Sliding Compound Miter Saw trouble s